tracker

TQMC

TQMC has acquired wide Domain Knowledge and Experience. You can FREELY access it here and here

DISCLAIMER: This matter here is a guide only. For authentic and up-to-date information, please contact TQMC.

The DIRECTIVES and STANDARDS listed here may have been subsequently REVISED . You must refer to the CURRENT REVISION and AMENDMENTS if any.

Friday, July 16, 2010

CE Marking - 10 STEPS

10 Steps to CE Marking

Step 1

Identify the Directive/s that is/are applicable to your product. You can download these directives free of charge from the EU website: www.newapproach.org.

Step 2

Identify the conformity assessment procedure that must be taken. This could be self-declaration, involve testing, inspection or quality system assessment from a Notified Body or a combination of these. The conformity assessment procedure will differ depending on your product and the Directive in respect of which you will be CE Marking. If you are unsure about which procedure to take please contact NSAI for advice.

Step 3

Determine the date by which you must take action. This will be the date that the Directive comes into force. The majority of Directives are already in force. In these cases, it is an offence to place a product on the market without CE Marking because it indicates a presumption of conformity with all relevant legislation.

Step 4

Identify if there are any Harmonized European Standards applicable to your product. These are not always mandatory for manufacturers although there is a presumption that conformity to these standards will give conformity to the relevant part of the Directive. Whenever possible or appropriate, manufacturers should follow harmonized standards.

Step 5

Ensure the product complies with all the essential requirements of the Directive(s). Take appropriate measures to comply or identify existing data and test reports.

Step 6

Identify whether independent assessment of your conformity to the Directive, or some aspects of it, is required from a Notified Body. This will be stated in the Directive and is dependent upon the product you are CE Marking. You must not affix CE Marking to your product until all necessary certifications have been obtained from the Notified Body.

Step 7

Maintain technical documentation required by the Directive(s). Your technical documentation should support your compliance with the requirements of the Directive. It is essential to retain this documentation.

Step 8

Prepare the Declaration of Conformity and the required supporting evidence. The Declaration of Conformity along with the Technical Documentation should be available to Competent Authorities (EU Members) upon request.


Step 9

Check that no other purely national requirements exist in the countries where the product will be sold. These may include national standards, labelling or packaging requirements.


Step 10

Affix CE Marking on your product and/or its packaging and accompanying literature as stated in the Directive.

For more information, see link below:

http://europa.eu.int/comm/enterprise/regulation/goods/index_en.htm



RH Rev. 1.0


Source

No comments:

Post a Comment