tracker

TQMC

TQMC has acquired wide Domain Knowledge and Experience. You can FREELY access it here and here

DISCLAIMER: This matter here is a guide only. For authentic and up-to-date information, please contact TQMC.

The DIRECTIVES and STANDARDS listed here may have been subsequently REVISED . You must refer to the CURRENT REVISION and AMENDMENTS if any.

Saturday, June 13, 2009

ETP

miniature plant for Plating Shops



Send us a question

Industrial Waste Treatment in Municipal ETP: References & Precedence?
I am working as a process engineer at a municipal sewage treatment plant of capacity 75000 cu.m/day. At present plant is working very nicely with the following effluent water parameters. TSS : 3 --- 5 PPM, BOD: 4 --- 6 PPM, COD: 15 --- 18 PPM

The plant is located in KSA and plant is working on principle of activated sludge process with a non-conventional continuous channel hydraulic design called ‘CARROUSEL’. The treatment plant consists of inlet area with mechanical bar screens, biological odor control system and grit removal unit, sewage distribution proportion chamber, aeration tanks, settlement tanks, activated sludge return pumping station, sludge distribution chamber, filtration house, chlorination system, chlorine contact tanks, sludge thickening tanks and sludge dewatering system (Belt filter presses).

But due to some problems now ministry wants to dump all industrial waste also with the raw municipal sewage for the treatment. Can you please provide me some references for the municipal treatment plants which are facing lot of process and operation problems due to dumping of industrial waste water for the treatment at the same facility to satisfy the ministry personnel to avoid them doing this or some other data which will satisfy them to look some other options for the industrial waste water treatment.

Nadeem
aknawan@yahoo.com


No comments:

Post a Comment